Lunchbox locker

[coolin4u]

Looking for an aussie,spartan or equivalent locker for the dana 30 in my yj.

[Myz28u]

I went with richmond lock rite in my old yj. It worked great and was super easy to install

 

sent using super pulsar technology

[coolin4u]

super easy is a plus as it will be my first install,will check them out.

[xjtrailrider]

On a D-30 you will have to pull the axle shafts, the carrier, mark the bearing caps by the side they are on and what is the top, remove the ring gear, drive the cold rolled pin out of the cross shaft and remove the side/spider gears. Install locker and cross shaft/pin, check air gaps to specs, install the ring gear with new bolts(All ring gear bolts are TTY, torque to yield), use red locktite 271 on the RG bolts using a cross torque pattern pulling the ring gear in to the carrier evenly and then torque to spec(I think 65ftlbs, i will look it up) and then install the carrier back into the housing walking the bearing caps in evenly side to side and top to bottom, torque to spec, 65ftlbs

[coolin4u]

thanks guys, will definitely refer back here ^^^ for reference when i find one,hoping one shows uo somewhere in the next month or so,if not i may have to go new to have it before the trails start to open up.